To ensure you receive the correct Slab Saver display, we need the maximum thickness of your CGC case.
What You’ll Need
-
A ruler, tape measure, or digital caliper
-
Your CGC-graded comic
Step 1 — Place the Case on a Flat Surface
Lay your CGC case flat on a table or other level surface.
Step 2 — Find the Thickest Point
Important: Do not measure only the flat center of the case.
Many CGC cases have raised or elevated surfaces around the corners and edges, which can make the case thicker than the center.
Measure from the front-most surface to the back-most surface at the thickest point of the case.
Step 3 — Check the Corners
Pay particular attention to the raised corners and other elevated areas. Check multiple locations and identify the measurement that is largest.
Step 4 — Enter Your Measurement
Enter the maximum thickness you measured in inches or millimeters (mm).
When in doubt, use the largest measurement. This helps ensure your Slab Saver display provides the proper fit for your specific CGC case.